Red-D-Arc EXTREME 360 Spécifications télécharger pdf (Page 20)

9.Control of the ArcPower 360 via RS-232

9.1Wiring an RS-232 serial port

9-pin D connector (male)

Front view of the socket:

RS-232 cable:

9-pin D connector- female 9-pin D connector - female

ArcPower driver PC

Pin 1: Pin 1:

Pin 2: Received Data Pin 2: Received Data

Pin 3: Transmited data Pin 3: Transmited data

Pin 4: Pin 4:

Pin 5: Signal ground Pin 5: Signal ground

Pin 6: Pin 6:

Pin 7: Pin 7:

Pin 8: Pin 8:

Pin 9: Pin 9:

The maximum cable length according to the standard is 15 metres or the cable length equals to a capacitance

of 2500 pF.

9.2 Zone number

The number of the zone distinguishes individual zones of the ArcPower 360 which is controled via RS-232

interface.

The sequence of the zones is following:

9.3 Setting a serial port of PC

The serial port of your personal computer hould be congured as follows:

9600 Baud,8 Data Bits,Non Parity,One Stop Bit,No Flow Control Required.

9.4 Zone commands

The ArcPower 360 uses the 3 types of the zone commands which can be used in a suitable software running

on PC.

All zone commands stated below have to be send to the ArcPower 360 in ASCII codes.

Pin 1: Not connected

Pin 2: Received Data

Pin 3: Transmitted Data

Pin 4:

Pin 5: Signal Ground

Pin 6:

Pin 7:

Pin 8:

Pin 9: Not connected

1 2 ... 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Red-D-Arc EXTREME 360 Spécifications Page 20